Relubrication based on fixed schedules is common practice. But it doesn’t necessarily reflect what a bearing actually needs.
Together with EWD – Esterer WD GmbH, one of the world’s leading manufacturers of sawmill systems, HCP Sense equipped the bearing arrangement of a new profiling unit with its intelligent sensor technology.
Previously, relubrication was carried out at fixed time intervals. The result?
- Too little grease leads to increased bearing wear and potential damage.
- Too much grease causes rising temperatures, higher lubricant consumption and additional maintenance effort.
Our solution: We measure the lubrication condition directly inside the bearing. As soon as it falls below a predefined threshold, the system sends a signal to the centralized lubrication system, which then supplies the appropriate amount of grease based on the actual measured condition.
The benefits for the customer:
- Relubrication only when the bearing actually needs it.
- No unnecessary overlubrication during periods of lower operating loads.
- Reduced grease consumption.
- Direct integration into the existing EWD machine control system, without major modifications to the shaft or housing.
The result: Relubrication is no longer just a routine maintenance task. It becomes an intelligent, condition-based protection function.

